大众新一代宝来变速怎么驾驶，请问大众新宝来

　　大众新一代宝来变速怎么驾驶，请问大众新宝来怎么拉高速？

　　最近有很多热心网友都十分关心大众新一代宝来变速怎么驾驶，请问大众新宝来怎么拉高速？这个问题。还有一部分人想了解大众新一代宝来变速怎么驾驶。对此，和记百科小编「醉看伊人戏」收集了相关的教程，希望能给你带来帮助。

　　

大众新宝来怎么拉高速

 

　　1、更换机油，换完之后行驶数公里，让新机油和发动机充分接触。

　　2、从1挡开始到3挡，每一个档位从低到高拉起来，每档位适应三到四个转速，最后都维持满转速表4/5左右的转速，每档位分别坚持总时间5分钟即可。3档拉完直接连续升到最高档，松油门让车自然减速后，停车熄火5分钟。

　　3、1到3档正常开起来，3档时把转速再踩上去后升4档坚持个5分钟，然后再5档，通常大多数的变速箱4或5档拉完就差不多。

　　4、拉完高速记得马上去换机油。

　　

大众新一代宝来变速怎么驾驶

 

　　1、首先查看车辆外观和轮胎情况，调整好座位，系好安全带，看前后左右是否安全、后视镜是否适合自己观看；

　　2、自动挡的车只有油门和刹车两个踏板，其中左边的是刹车，右边的是油门，这个顺序一定要记清楚。在启动车前首先踏住左边的刹车踏板；

　　3、插入钥匙，发动车辆、查看车的仪表是否正常。检查仪表上是否有报警灯显示。确认油量计中油量是否足够、右脚踩住刹车，用右手放下手刹；

　　4、将挡位从P挡换到D挡。(注意此时右脚仍踩着刹车)、松开刹车，右脚移到油门踏板上，轻踩着行进。

　　

　　【英文介绍/For English】：

　　

　　1. Change the oil, and drive for several kilometers after the change, so that the new oil and the engine are fully contacted.

　　2. From the 1st gear to the 3rd gear, each gear is pulled up from low to high, each gear is adapted to three to four speeds, and finally maintains the speed of about 4/5 of the full tachometer, and each gear maintains the total speed. The time is 5 minutes. After the 3rd gear is pulled, it will directly rise to the highest gear continuously. After releasing the accelerator to let the car decelerate naturally, stop and turn off the engine for 5 minutes.

　　3. The 1st to 3rd gears are normally opened. In the 3rd gear, step on the speed again, then increase the 4th gear for 5 minutes, and then go to the 5th gear. Usually, most gearboxes are almost finished with the 4th or 5th gear.

　　4. Remember to change the oil immediately after pulling high speed.